THEFT DETERRENT SYSTEM > ECU Power Source Circuit |

| 1.CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU - BATTERY AND BODY GROUND) |
![]() |
Disconnect the T33 theft warning ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| T33-1 (E) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| T33-4 (+B1) - Body ground | Always | 11 to 14 V |
| T33-14 (+B2) - Body ground | Always | 11 to 14 V |
| *a | Front view of wire harness connector (to Theft Warning ECU Assembly) |
|
| ||||
| OK | ||
| ||