Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Back Door Courtesy Switch Circuit


DESCRIPTION

The theft warning ECU assembly detects the condition of the back door courtesy switch.

WIRING DIAGRAM


B276107E23


INSPECTION PROCEDURE

1.INSPECT BACK DOOR LOCK ASSEMBLY (BACK DOOR COURTESY SWITCH)


  1. Remove the back door lock assembly (Click here).


    B276592E01


    Text in Illustration 
    *a
    Latch Condition
    *b
    Open-latch
    *c
    Half-latch
    *d
    Full-latch
    *e
    Over-latch
    -
    -

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Open-latch (ON)
    Below 1 Ω
    Half-latch (ON)
    Below 1 Ω
    Full-latch (OFF)
    10 kΩ or higher
    Over-latch (OFF)
    10 kΩ or higher



NG
REPLACE BACK DOOR LOCK ASSEMBLY (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (BACK DOOR LOCK - THEFT WARNING ECU AND BODY GROUND)
  1. Disconnect the B9 back door lock assembly (back door courtesy light switch) connector.

  1. Disconnect the T33 theft warning ECU assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    B9-2 - T33-7 (CTY)
    Always
    Below 1 Ω
    B9-2 or T33-7 (CTY) - Body ground
    Always
    10 kΩ or higher
    B9-1 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)