Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)

DTC    41    Front Air Mix Damper Control Servo Motor Circuit

for Preparation Click here


DESCRIPTION

The air mix damper servo sub-assembly sends pulse signals to inform the air conditioning amplifier assembly of the air mix control damper position. The air conditioning amplifier assembly activates the motor (normal or reverse) based on the signals to move the air mix control damper to any position. As a result, the air mix control damper varies the mixture of hot air from the heater core and cold air from the evaporator so that the temperature of the air blowing toward the driver and front passenger side is as requested.

HINT:
This DTC is also output if the damper and damper link are malfunctioning or unable to move properly. When this DTC is output, confirm that the mechanical parts of the damper and damper link are not defective or damaged.


DTC Code
DTC Detection Condition
Trouble Area
41
The air mix control damper position does not change when the air conditioning amplifier assembly operates the air mix damper servo sub-assembly.
  1. Air mix damper servo sub-assembly
  2. Air conditioning amplifier assembly
  3. Harness or connector

WIRING DIAGRAM


E233156E10


INSPECTION PROCEDURE

NOTICE:
When DTC 41, 42 and 43 are output at same time, there would be malfunctioning on power source circuit (Click here).

1.CHECK HARNESS AND CONNECTOR (AIR MIX DAMPER SERVO - AIR CONDITIONING AMPLIFIER)
  1. Disconnect the D12 air mix damper servo sub-assembly connector.

  1. Disconnect the A44 and A43 air conditioning amplifier assembly connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D12-5 (MHD) - A44-17 (AMH)
    Always
    Below 1 Ω
    D12-4 (MCD) - A44-19 (AMC)
    D12-3 (MHP) - A43-23 (PMB)
    D12-2 (MCP) - A43-24 (PMA)
    D12-1 (SG) - A43-20 (SG-1)
    D12-1 (SG) - Body ground
    Always
    10 kΩ or higher
    D12-2 (MCP) - Body ground
    D12-3 (MHP) - Body ground
    D12-4 (MCD) - Body ground
    D12-5 (MHD) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.REPLACE AIR MIX DAMPER SERVO SUB-ASSEMBLY
  1. Temporally replace the air mix damper servo sub-assembly with a new or normally functioning one (Click here).

  1. Check the air mix control damper operates normally.

    OK:
    Air mix control damper operates normally.

    Result 
    Result
    Proceed to
    OK
    A
    NG (When troubleshooting according to problem symptoms table.)
    B
    NG (When troubleshooting according to DTC.)
    C



B
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

C
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)
A

END (AIR MIX DAMPER SERVO SUB-ASSEMBLY IS DEFECTIVE)