DTC 41 Front Air Mix Damper Control Servo Motor Circuit |
| DTC Code | DTC Detection Condition | Trouble Area |
| 41 | The air mix control damper position does not change when the air conditioning amplifier assembly operates the air mix damper servo sub-assembly. |
|

| 1.CHECK HARNESS AND CONNECTOR (AIR MIX DAMPER SERVO - AIR CONDITIONING AMPLIFIER) |
Disconnect the D12 air mix damper servo sub-assembly connector.
Disconnect the A44 and A43 air conditioning amplifier assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D12-5 (MHD) - A44-17 (AMH) | Always | Below 1 Ω |
| D12-4 (MCD) - A44-19 (AMC) | ||
| D12-3 (MHP) - A43-23 (PMB) | ||
| D12-2 (MCP) - A43-24 (PMA) | ||
| D12-1 (SG) - A43-20 (SG-1) | ||
| D12-1 (SG) - Body ground | Always | 10 kΩ or higher |
| D12-2 (MCP) - Body ground | ||
| D12-3 (MHP) - Body ground | ||
| D12-4 (MCD) - Body ground | ||
| D12-5 (MHD) - Body ground |
|
| ||||
| OK | |
| 2.REPLACE AIR MIX DAMPER SERVO SUB-ASSEMBLY |
Temporally replace the air mix damper servo sub-assembly with a new or normally functioning one (Click here).
Check the air mix control damper operates normally.
| Result | Proceed to |
| OK | A |
| NG (When troubleshooting according to problem symptoms table.) | B |
| NG (When troubleshooting according to DTC.) | C |
|
| ||||
|
| ||||
| A | ||
| ||