Home › BODY ELECTRICAL › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM

WIRELESS DOOR LOCK CONTROL SYSTEM > No Answer-back

for Preparation Click here


DESCRIPTION

In some cases, wireless control functions are normal but one or more of the following may occur:
  1. The hazard warning light answer-back function is not normal (the theft warning ECU's turn signal flasher relay output may be malfunctioning).
  2. The security horn answer back function is not normal (the security horn signal output may be malfunctioning)*.

HINT:
*: The security horn assembly applies only if the wireless answer-back function has been customized so that the hazard warning lights flash and the security horn assembly sounds.


WIRING DIAGRAM


B276573E07


INSPECTION PROCEDURE

NOTICE:
When replacing the theft warning ECU assembly, refer to the registration procedures (Click here).

1.CHECK WIRELESS DOOR LOCK CONTROL FUNCTION
  1. Check the wireless door lock functions by operating the transmitter switches.
    Result 
    Result
    Proceed to
    Only hazard warning light and side turn signal light answer-back does not occur
    A
    Only security horn answer-back does not occur*
    B

HINT:
The security horn assembly applies only if the wireless answer-back function has been customized so that the hazard warning lights flash and the security horn assembly sounds.



B
Go to THEFT DETERRENT SYSTEM
A


2.CHECK HAZARD WARNING LIGHT
  1. Check that the hazard warning lights flash continuously when the hazard warning signal switch assembly is pressed.

    OK:
    Hazard warning lights flash when hazard warning signal switch assembly is pressed.



NG
Go to LIGHTING SYSTEM
OK


3.CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU - TURN SIGNAL FLASHER)
  1. Disconnect the T33 theft warning ECU assembly connector.

  1. Disconnect the T34 turn signal flasher assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    T33-28 (HAZD) - T23-8 (HAZ)
    Always
    Below 1 Ω
    T34-28 (HAZD) or T23-8 (HAZ) - Body ground
    Always
    10 kΩ or higher



OK
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE THEFT WARNING ECU ASSEMBLY