DTC U0101 Lost Communication with TCM |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Ignition switch ON for 3 seconds | Both conditions are met for 1.25 seconds (1 trip detection logic):
|
|

| 1.CHECK FOR ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC U0101) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| U0101 is output | A |
| U0101 and other DTCs are output | B |
|
| ||||
| A | |
| 2.INSPECT TCM POWER SOURCE CIRCUIT (POWER SOURCE AND BODY GROUND) |
![]() |
Disconnect the TCM connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| T35-5 (BATT) - T19-1 (E1) | Always | 11 to 14 V |
| *a | Rear view of wire harness connector (to TCM) |
Reconnect the TCM connector.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (ECM - TCM) |
Disconnect the TCM connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E27-24 (CAN+) - T35-21 (CAN+) | Always | Below 1 Ω |
| E27-18 (CAN-) - T35-20 (CAN-) | Always | Below 1 Ω |
| E27-24 (CAN+) or T35-21 (CAN+) - Body ground or other terminals | Always | 1 MΩ or higher |
| E27-18 (CAN-) or T35-20 (CAN-) - Body ground or other terminals | Always | 1 MΩ or higher |
Reconnect the TCM connector.
Reconnect the ECM connector.
|
| ||||
| OK | |
| 4.REPLACE ECM |
Replace the ECM (Click here).
| NEXT | |
| 5.CHECK WHETHER DTC OUTPUT RECURS (DTC U0101) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| No DTC is output | A |
| U0101 is output | B |
|
| ||||
| A | ||
| ||