LIGHTING SYSTEM > Vehicle Speed Signal Circuit |

| 1.READ VALUE USING INTELLIGENT TESTER (VEHICLE SPEED) |
Using the intelligent tester, read the Data List (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Vehicle Speed | Vehicle speed / 0 to 327.67 km/h | Actual vehicle speed | - |
|
| ||||
| OK | ||
| ||
| 2.CHECK COMBINATION METER ASSEMBLY |
![]() |
Remove the combination meter with its connector still connected (Click here).
Connect an oscilloscope to the combination meter connector.
Check the waveform.
| Item | Content |
| Terminal No. (Symbol) | C26-6 - Body ground |
| Tool setting | 5 V/DIV., 20 ms./DIV. |
| Condition | Vehicle is driven at approximately 20 km/h (12 mph) |
| *a | Component with harness connected (Combination Meter Assembly) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - HEADLIGHT LEVELING ECU ASSEMBLY) |
Disconnect the C26 combination meter connector.
Disconnect the H27 headlight leveling ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C26-6 - H27-16 (SPDR) | Always | Below 1 Ω |
| C26-6 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||