Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Data Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the navigation receiver assembly via this circuit.

WIRING DIAGRAM


E278092E06


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
  1. Disconnect the N12 navigation receiver assembly connector.

  1. Disconnect the N13 No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    N12-2 (US1-) - N13-2 (US1-)
    Always
    Below 1 Ω
    N12-3 (US1+) - N13-3 (US1+)
    Always
    Below 1 Ω
    N12-2 (US1-) - Body ground
    Always
    10 kΩ or higher
    N12-3 (US1+) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)