Home › RESTRAINTS › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY (for Power Seat)

FRONT SEAT INNER BELT ASSEMBLY (for Power Seat) > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT SEAT ASSEMBLY LH
  1. Remove the front seat assembly (Click here).



4. REMOVE FRONT SEAT ASSEMBLY RH
  1. Remove the front seat assembly (Click here).



5. REMOVE FRONT SEAT CUSHION SHIELD INNER LH


    B211298
  1. Remove the 2 screws.



    B211299
  1. Remove the 3 screws.

  1. Detach the claw and guide.

  1. Remove the front seat cushion shield LH with the front inner No. 1 seat cushion shield LH.



6. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH
  1. Disconnect the connector and detach the 3 clamps.



    B210575
  1. Remove the nut and front seat inner belt assembly.

  1. Remove the buckle cover.



7. REMOVE FRONT SEAT INNER BELT ASSEMBLY RH


B087812E02
  1. Disconnect the 2 connectors and detach the 2 clamps.

  1. Remove the nut and front seat inner belt assembly.

  1. Remove the buckle cover.