DTC P0047 Turbocharger/Supercharger Boost Control "A" Circuit Low |
DTC P0048 Turbocharger/Supercharger Boost Control "A" Circuit High |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0047 | All of following conditions met for 1 second or more (1 trip detection logic):
|
|
| P0048 | DC motor current 6.5 A or more for 0.5 seconds or more (1 trip detection logic) |
|
| 1.INSPECT TURBOCHARGER SUB-ASSEMBLY (DC MOTOR OPERATION) |
Turn the ignition switch ON.
Turn the ignition switch OFF and check the DC motor operation.

|
| ||||
| NG | |
| 2.INSPECT TURBOCHARGER SUB-ASSEMBLY (DC MOTOR) |
![]() |
Disconnect the T10 DC motor connector.
Measure the resistance of the DC motor.
| Tester Connection | Specified Condition |
| M+ (2) - M- (1) | 1 to 100 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (DC MOTOR - TURBO MOTOR DRIVER) |
![]() |
Disconnect the T10 DC motor connector.
Disconnect the T32 turbo motor drive connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| T32-12 (M+) - T10-2 (M+) | Below 1 Ω |
| T32-5 (M-) - T10-1 (M-) | Below 1 Ω |
| T32-12 (M+) or T10-2 (M+) - Body ground | 10 kΩ or higher |
| T32-5 (M-) or T10-1 (M-) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.REPLACE TURBO MOTOR DRIVER |
| NEXT | |
| 5.CHECK IF DTC OUTPUT RECURS (DTC P0047 AND/OR P0048) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Clear the DTC (Click here).
Start the engine.
Perform the test drive.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Display (DTC Output) | Proceed to |
| P0047 and/or P0048 | A |
| No output | B |
|
| ||||
| A | ||
| ||