TURBOCHARGER > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE INTERCOOLER ASSEMBLY |
| 4. REMOVE FRONT EXHAUST PIPE ASSEMBLY |
| 5. REMOVE FRONT WHEEL RH |
| 6. REMOVE NO. 1 ENGINE UNDER COVER |
| 7. REMOVE NO. 2 ENGINE UNDER COVER |
| 8. DRAIN ENGINE COOLANT |
![]() |
Drain the coolant by removing the reservoir cap and, using a wrench, remove the vent plug.
Loosen the cylinder block drain cock plug and the radiator drain cock plug.

| 9. REMOVE FRONT FENDER APRON SEAL UPPER |
Remove the 5 clips and front fender apron seal upper.
| 10. REMOVE FRONT FENDER SEAL |
Remove the 5 clips and front fender seal.
| 11. REMOVE AIR CLEANER ASSEMBLY |
Disconnect the mass air flow meter connector.
Loosen the hose clamp.
Remove the 2 bolts and air cleaner.
| 12. REMOVE VENTILATION PIPE |
![]() |
Remove the bolt and disconnect the 2 ventilation hoses and ventilation pipe.
| 13. REMOVE COMPRESSOR INLET ELBOW |
![]() |
Disconnect the 2 connectors from the turbocharger.
Detach the wire harness clamp.
Remove the 2 nuts, compressor inlet elbow and gasket.
| 14. REMOVE NO. 1 TURBO INSULATOR |
![]() |
Remove the 2 bolts and No. 1 turbo insulator.
| 15. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR |
![]() |
Remove the bolt and No. 1 exhaust manifold heat insulator.
| 16. REMOVE NO. 1 TURBO WATER HOSE |
![]() |
Remove the 2 No. 1 turbo water hoses.
| 17. REMOVE TURBINE OUTLET ELBOW |
![]() |
Remove the 3 nuts, turbine outlet elbow and gasket.
| 18. REMOVE TURBOCHARGER STAY |
![]() |
Remove the 2 bolts, nut and turbocharger stay.
| 19. REMOVE TURBO OIL INLET PIPE SUB-ASSEMBLY |
![]() |
Remove the 2 bolts, 2 nuts, union bolt, turbo oil inlet pipe and 3 gaskets.
| 20. REMOVE TURBOCHARGER SUB-ASSEMBLY |
![]() |
Remove the 3 nuts, turbocharger and gasket.
| 21. REMOVE NO. 1 TURBO WATER PIPE SUB-ASSEMBLY |
![]() |
Remove the 2 nuts, bolt, No. 1 turbo water pipe and gasket.