Home › ENGINE · 1KD-FTV › ENGINE CONTROL SYSTEM › ECD SYSTEM (for i-ART)

ECD SYSTEM (for i-ART) > Injector Circuit

for Preparation Click here


DESCRIPTION

The injector driver drives the injectors at high speeds with a high-voltage DC/DC converter. The ECM constantly monitors the injector driver and stops the engine if an abnormal condition is detected.

WIRING DIAGRAM

Refer to DTC P0201 .

INSPECTION PROCEDURE

NOTICE:
  1. Inspect the fuses of circuits related to this system before performing the following inspection procedure.
  2. After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).

1.CHECK INJECTOR DRIVER (POWER SOURCE)


    A204910E32
  1. Disconnect the injector driver connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    I17-2 (+B) - I17-4 (GND)
    Ignition switch ON
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Injector Driver)

  1. Reconnect the injector driver connectors.



OK
CHECK FOR INTERMITTENT PROBLEMS (Click here)
NG


2.INSPECT NO. 1 INTEGRATION RELAY (EDU RELAY)
  1. Inspect the No. 1 integration relay (EDU relay) .



NG
REPLACE NO. 1 INTEGRATION RELAY (EDU RELAY)
OK


3.CHECK HARNESS AND CONNECTOR (INJECTOR DRIVER - NO. 1 INTEGRATION RELAY)
  1. Remove the No. 1 integration relay from the engine room relay block and junction block assembly.

  1. Disconnect the injector driver connector.

  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:

    Tester Connection
    Condition
    Specified Condition
    I17-2 (+B) - 1J-8
    Always
    Below 1 Ω
    I17-4 (GND) - Body ground
    Always
    Below 1 Ω
    1J-5 - 1J-6
    Always
    Below 1 Ω
    I17-2 (+B) or 1J-8 - Body ground
    Always
    10 kΩ or higher
    1J-5 or 1J-6 - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the injector driver connector.

  1. Reinstall the No. 1 integration relay.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (ECM - NO. 1 INTEGRATION RELAY)
  1. Remove the No. 1 integration relay from the engine room relay block and junction block assembly.

  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:

    Tester Connection
    Condition
    Specified Condition
    E31-12 (IREL) - 1J-7
    Always
    Below 1 Ω
    E31-12 (IREL) or 1J-7 - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the ECM connector.

  1. Reinstall the No. 1 integration relay.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM (Click here)