FUEL SENDER GAUGE ASSEMBLY (for Fuel Sub Tank) > INSTALLATION |
| 1. INSTALL FUEL SUCTION PLATE SUB-ASSEMBLY |
Install a new fuel suction tube set gasket.
![]() |
Install the fuel suction plate sub-assembly to the auxiliary fuel tank as shown in the illustration.
![]() |
While holding the fuel suction plate sub-assembly by hand to prevent it from tilting, align the mark on a new fuel pump gauge retainer with the start mark on the auxiliary fuel tank and tighten the fuel pump gauge retainer 720° by hand.
| 2. CONNECT NO. 4 FUEL HOSE |
Connect the No. 4 fuel hose.
Connect the fuel sender gauge connector.
| 3. ADD FUEL |
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 5. INSPECT FOR FUEL LEAK (for Fuel Sub Tank) |
Start the engine.
Check for fuel leaks.
Check that there are no fuel leaks from the fuel system after doing any maintenance or repairs. If there is a fuel leak, repair or replace parts as necessary.