Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM

TOYOTA PARKING ASSIST-SENSOR SYSTEM > Clearance Warning Buzzer Circuit

for Preparation Click here


DESCRIPTION

The clearance warning ECU receives the No. 1 ultrasonic sensor signal to sound the No. 1 clearance warning buzzer.

WIRING DIAGRAM


E168857E04


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NO. 1 CLEARANCE WARNING BUZZER - CLEARANCE WARNING ECU)


    E149952E06
  1. Disconnect the C24 No. 1 clearance warning buzzer connector.



    E149933E68
  1. Disconnect the C25 clearance warning ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    C24-2 - C25-12 (BBZ)
    Always
    Below 1 Ω
    C24-2 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (NO. 1 CLEARANCE WARNING BUZZER - BATTERY)


    E149952E07
  1. Disconnect the C24 No. 1 clearance warning buzzer connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    C24-1 - Body ground
    Ignition switch ON
    11 to 14 V
    C24-1 - Body ground
    Ignition switch off
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE NO. 1 CLEARANCE WARNING BUZZER
  1. Replace the No. 1 clearance warning buzzer (Click here).


NEXT


4.CHECK NO. 1 CLEARANCE WARNING BUZZER OPERATION
  1. Check that the No. 1 clearance warning buzzer sounds.

    OK:
    No. 1 clearance warning buzzer sounds.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END (NO. 1 CLEARANCE WARNING BUZZER IS DEFECTIVE)