DTC C1282 Center Differential Lock Position Switch |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1282 | Stored during Test Mode. |
|

| 1.CHECK TERMINAL VOLTAGE (EXI TERMINAL) |
Set the vehicle to the center differential lock state using the transfer shift lever.
Turn the ignition switch off.
![]() |
Disconnect the skid control ECU (brake actuator assembly) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S25-20 (EXI) - Body ground |
| Below 1.5 V |
Connect the skid control ECU (brake actuator assembly) connector.
Set the vehicle to the center differential free state using the transfer shift lever.
Turn the ignition switch off.
Disconnect the skid control ECU (brake actuator assembly) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S25-20 (EXI) - Body ground |
| 11 to 14 V |
| *a | Front view of wire harness connector (to Skid Control ECU [Brake Actuator Assembly]) |
|
| ||||
| OK | |
| 2.CHECK TEST MODE DTC |
Switch the vehicle to Test Mode, check the H to LL shift operation, and then check that Test Mode DTC C1282 is cleared (Click here).
| Result | Proceed to |
| Test Mode DTC is not cleared | A |
| Test Mode DTC is cleared | B |
|
| ||||
| A | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (EXI CIRCUIT) |
Turn the ignition switch off.
Disconnect the skid control ECU (brake actuator assembly) connector.
Disconnect the center differential lock position switch (No. 3 transfer indicator switch) connector.
Disconnect the C27 combination meter connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S25-20 (EXI) - T4-2 | Always | Below 1 Ω |
| S25-20 (EXI) - Body ground | Always | 10 kΩ or higher |
| T4-1 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||