VEHICLE STABILITY CONTROL SYSTEM > Brake Warning Light does not Come ON |
| 1.CHECK BRAKE WARNING LIGHT |
Turn the ignition switch off.
Disconnect the skid control ECU (brake actuator assembly) connector.
Turn the ignition switch to ON.
Check that the brake warning light comes on.
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER AND PARKING BRAKE SWITCH) |
Turn the ignition switch off.
Disconnect the skid control ECU (brake actuator assembly) connector.
Disconnect the C26 combination meter connector.
Disconnect the parking brake switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S25-8 (BRL) - C26-26 | Always | Below 1 Ω |
| S25-8 (BRL) - Body ground | Always | 10 kΩ or higher |
| S25-29 (PKB) - P3-1 | Always | Below 1 Ω |
| S25-29 (PKB) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (BRAKE WARNING LIGHT) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Brake Warning Light | Brake warning light | Warning light ON / OFF | Observe the combination meter. |
When performing the Brake Warning Light Active Test, check Brake Warning Light in the Data List.
| Tester Display | Measurement Item / Range | Normal Condition | Diagnostic Note |
| Brake Warning Light | Brake warning light / ON or OFF | ON: Brake warning light on OFF: Brake warning light off | - |
| Result | Proceed to | |
| Data List Display | Data List Display When Performing Active Test ON/OFF Operation | |
| ON | Does not change between ON and OFF | A |
| Changes between ON and OFF | B | |
| OFF | Does not change between ON and OFF | A |
| Changes between ON and OFF | B | |
|
| ||||
| A | ||
| ||