VEHICLE STABILITY CONTROL SYSTEM > VSC OFF Indicator Light Remains ON |

| 1.READ VALUE USING INTELLIGENT TESTER (TRC/VSC OFF MODE) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
| Tester Display | Measurement Item / Range | Normal Condition | Diagnostic Note |
| TRC/VSC Off Mode | VSC OFF switch / Normal, Unknown, TRC OFF or VSC OFF | Normal: Normal mode TRC OFF: TRC off mode VSC OFF: VSC off mode | - |
Check that the mode display changes according to VSC OFF switch operation.
|
| ||||
| OK | |
| 2.INSPECT BRAKE ACTUATOR ASSEMBLY |
Turn the ignition switch off.
Disconnect the skid control ECU (brake actuator assembly) connector.
Turn the ignition switch to ON.
Check the state of the VSC OFF indicator light.
| Result | Proceed to |
| VSC OFF indicator light turns off | A |
| VSC OFF indicator light does not turn off | B |
|
| ||||
| A | ||
| ||
| 3.INSPECT VSC OFF SWITCH |
Turn the ignition switch off.
Remove the VSC OFF switch (Click here).
Inspect the VSC OFF switch (Click here).
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - VSC OFF SWITCH) |
Turn the ignition switch off.
Disconnect the VSC OFF switch connector.
Disconnect the skid control ECU (brake actuator assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S25-30 (CSW) - V8-3 | Always | Below 1 Ω |
| S25-30 (CSW) - Body ground | Always | 10 kΩ or higher |
| V8-4 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 5.CHECK TERMINAL VOLTAGE (EXI3 TERMINAL) |
![]() |
Turn the ignition switch off.
Disconnect the skid control ECU (brake actuator assembly) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| S25-28 (EXI3) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Skid Control ECU [Brake Actuator Assembly]) |
|
| ||||
| OK | ||
| ||
| 6.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER) |
Turn the ignition switch off.
Disconnect the skid control ECU (brake actuator assembly) connector.
Disconnect the C27 combination meter connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S25-15 (VSCW) - C27-16 | Always | Below 1 Ω |
| S25-15 (VSCW) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||