Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › REAR AIRBAG SENSOR

REAR AIRBAG SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL REAR AIRBAG SENSOR LH


    B214756
  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the battery negative (-) terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  1. Install the rear airbag sensor with the bolt.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

    NOTICE:
    1. If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
    2. When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

  1. Check that there is no looseness in the installation parts of the rear airbag sensor.

  1. Connect the connector.



2. INSTALL QUARTER INSIDE TRIM BOARD LH
  1. Connect the power point socket connector.

  1. Detach the 7 claws and 10 clips to install the quarter inside trim board.

  1. Install the clip.

  1. w/ Rear No. 2 Seat:

    1. Connect the rear No. 2 seat outer belt floor anchor with the bolt.

      Torque:
      42 N*m{ 428 kgf*cm , 31 ft.*lbf }

  1. Connect the rear No. 1 seat outer belt floor anchor with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

  1. Attach the 2 claws to install the outer lap belt anchor cover.

    HINT:
    Use the same procedure for both outer lap belt anchor covers.



3. INSTALL BACK DOOR SCUFF PLATE
  1. Attach the 4 claws, 2 guides and 6 clips to install the back door scuff plate.



4. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH


B276956E01
  1. Align the paint mark on the rear door opening trim weatherstrip with the mark position on the vehicle and install the rear door opening trim weatherstrip as shown in the illustration.
    Text in Illustration 
    *1
    Paint Mark
    *2
    Mark Position



5. INSTALL REAR DOOR SCUFF PLATE LH
  1. Attach the 2 clips and 7 claws to install the rear door scuff plate.



6. INSTALL REAR SEAT ASSEMBLY
  1. Install the rear seat assembly (Click here).



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


8. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).