REAR AIRBAG SENSOR > INSTALLATION |
| 1. INSTALL REAR AIRBAG SENSOR LH |
![]() |
Check that the ignition switch is off.
Check that the cable is disconnected from the battery negative (-) terminal.
Install the rear airbag sensor with the bolt.
Check that there is no looseness in the installation parts of the rear airbag sensor.
Connect the connector.
| 2. INSTALL QUARTER INSIDE TRIM BOARD LH |
Connect the power point socket connector.
Detach the 7 claws and 10 clips to install the quarter inside trim board.
Install the clip.
w/ Rear No. 2 Seat:
Connect the rear No. 2 seat outer belt floor anchor with the bolt.
Connect the rear No. 1 seat outer belt floor anchor with the bolt.
Attach the 2 claws to install the outer lap belt anchor cover.
| 3. INSTALL BACK DOOR SCUFF PLATE |
Attach the 4 claws, 2 guides and 6 clips to install the back door scuff plate.
| 4. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH |
![]() |
Align the paint mark on the rear door opening trim weatherstrip with the mark position on the vehicle and install the rear door opening trim weatherstrip as shown in the illustration.
| *1 | Paint Mark |
| *2 | Mark Position |
| 5. INSTALL REAR DOOR SCUFF PLATE LH |
Attach the 2 clips and 7 claws to install the rear door scuff plate.
| 6. INSTALL REAR SEAT ASSEMBLY |
Install the rear seat assembly (Click here).
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 8. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).