DTC CB-13 USB Over Current Detection |
| DTC Code | DTC Detection Condition | Trouble Area |
| CB-13 | An "iPod" or USB device overcurrent malfunction |
|

| 1.REPLACE USB DEVICE OR "iPod" |
Disconnect the USB device or "iPod" from the stereo jack adapter assembly.
Turn the ignition switch off.
Turn the ignition switch to ACC.
Connect a known good USB device or "iPod" to the stereo jack adapter assembly.
| NEXT | |
| 2.CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs and check if the same DTC occurs again.
|
| ||||
| OK | ||
| ||
| 3.CHECK RADIO RECEIVER ASSEMBLY |
![]() |
Disconnect the N4 No. 1 stereo jack adapter assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| N4-1 (UPI) - N4-4 (UJSG) | Always | 4.5 to 5.5 V |
| *a | Front view of wire harness connector (to No. 1 Stereo Jack Adapter Assembly) |
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - STEREO JACK ADAPTER) |
Disconnect the R33 radio receiver assembly connector.
Disconnect the N4 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R33-1 (USV1) - N4-1 (UPI) | Always | Below 1 Ω |
| R33-4 (UGD1) - N4-4 (UJSG) | Always | Below 1 Ω |
| R33-1 (USV1) - Body ground | Always | 10 kΩ or higher |
| R33-4 (UGD1) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||