Home › SECURITIES › THEFT DETERRENT › BLOCKING SYSTEM

BLOCKING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING


HINT:
  1. Use these procedures to troubleshoot the blocking system.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      1. If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CRANK ENGINE FOR MORE THAN 10 SECONDS
    1. Check that the engine cranks for more than 10 seconds.
      Result 
      Result
      Proceed to
      OK
      A
      NG (for 1KD-FTV)
      B
      NG (for 2TR-FE)
      C
      NG (for 1GR-FE)
      D
      NG (for 2TR-FBE)
      E



    B.
    Go to ECD SYSTEM

    C.
    Go to SFI SYSTEM

    D.
    Go to SFI SYSTEM

    E.
    Go to SFI SYSTEM
    A


    4.CHECK FOR DTC*
    1. Check for DTCs and note any codes that are output (Click here).

    2. Clear the DTCs (Click here).

    3. Based on the DTCs output above, try to force output of the same ECD system*1 or SFI system*2, engine immobiliser system and blocking system*3 DTCs by reproducing the monitoring conditions indicated by the DTCs.

      1. *1: for 1KD-FTV
      2. *2: for 2TR-FE, 1GR-FE, 2TR-FBE
      3. *3: w/ Blocking System
      Result 
      Result
      Proceed to
      DTC is not output.
      A
      ECD system DTC is output (for 1KD-FTV).
      B
      SFI system DTC is output (for 2TR-FE).
      C
      SFI system DTC is output (for 1GR-FE).
      D
      SFI system DTC is output (for 2TR-FBE).
      E
      Engine immobiliser system DTC is output.
      F
      Blocking system DTC is output.
      G



    B.
    Go to ECD SYSTEM

    C.
    Go to SFI SYSTEM

    D.
    Go to SFI SYSTEM

    E.
    Go to SFI SYSTEM

    F.
    Go to ENGINE IMMOBILISER SYSTEM

    G.
    Go to DIAGNOSTIC TROUBLE CODE CHART
    A


    5.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).
      Result 
      Result
      Proceed to
      Fault is not listed in the problem symptoms table.
      A
      Fault is listed in the problem symptoms table.
      B



    B.
    Go to step 7
    A


    6.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Terminals of ECU (Click here).


    NEXT


    7.ADJUST, REPAIR OR REPLACE

      NOTICE:
      1. When replacing the telephone transceiver assembly, instrument panel integration antenna assembly or mayday battery, refer to the Service Bulletin.
      2. When the telephone transceiver is replaced, it is necessary to set the contract mode.


    NEXT


    8.CONFIRMATION TEST

      NEXT

      END