FUEL INJECTOR (w/ Glow Plug Controller) > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY WITH NO. 2 EGR VALVE AND EGR COOLER |
| 4. REMOVE NO. 4 INJECTION PIPE SUB-ASSEMBLY |
![]() |
Remove the bolt, nut and 2 No. 2 injection pipe clamps.
![]() |
Using a 17 mm union nut wrench, loosen the union nuts and remove the No. 4 injection pipe.
| 5. REMOVE WIRING HARNESS CLAMP BRACKET |
![]() |
Detach the wire harness clamp.
| *1 | Wiring Harness Clamp Bracket |
Remove the bolt and wiring harness clamp bracket.
| 6. REMOVE NO. 2 FUEL PIPE |
![]() |
Using a 6 mm hexagon wrench, remove the supply pump hollow screw and gasket.
![]() | Supply Pump Hollow Screw |
![]() | Fuel Check Valve |
Remove the fuel check valve, No. 2 fuel pipe and gasket.
| 7. REMOVE NO. 3 NOZZLE LEAKAGE PIPE |
![]() |
Disconnect the 3 fuel hoses.
![]() | Fuel Check Valve |
Remove the 2 bolts.
Remove the fuel check valve, gasket and No. 3 nozzle leakage pipe.
| 8. REMOVE NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY |
![]() |
Remove the 3 bolts.
![]() | Union Bolt |
Remove the union bolt, gasket and No. 2 nozzle leakage pipe.
| 9. REMOVE WIRING HARNESS CLAMP BRACKET |
![]() |
Detach the 6 wire harness clamps.
Remove the 3 bolts and 2 wiring harness clamp brackets.
| 10. REMOVE NO. 2 CYLINDER HEAD COVER SUB-ASSEMBLY |
![]() |
Remove the 3 bolts and No. 2 cylinder head cover.
| 11. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY |
![]() |
Using a small screwdriver, remove the nozzle holder seal by prying between the nozzle holder seal and the cutout part of the cylinder head cover.
Disconnect the ventilation hose.
![]() |
Remove the 10 bolts, 2 nuts, cylinder head cover and cylinder head cover gasket.
![]() |
Remove the 4 No. 3 cylinder head cover gaskets from the cylinder head cover.
| 12. REMOVE INJECTOR ASSEMBLY |
![]() |
Remove the union bolt, 4 injector hollow screws, 5 gaskets and nozzle leakage pipe.
| *1 | Union Bolt |
![]() |
Remove the 4 bolts, 4 washers, 4 No. 1 nozzle holder clamps and 4 injectors.
Remove the O-ring from each injector.
Remove the 4 injection nozzle seats from the cylinder head.