Home › ENGINE ยท 1KD-FTV › FUEL › COMMON RAIL (w/ Glow Plug Controller)

COMMON RAIL (w/ Glow Plug Controller) > REMOVAL

for Preparation Click here


NOTICE:
  1. When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.
  2. When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.
  3. After removing the injection pipes and fuel inlet pipe, clean them with a brush and compressed air.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY WITH NO. 2 EGR VALVE AND EGR COOLER
(Click here)


4. REMOVE NO. 4 INJECTION PIPE SUB-ASSEMBLY


    A271613
  1. Remove the bolt, nut and 2 No. 2 injection pipe clamps.



    A271614
  1. Using a 17 mm union nut wrench, loosen the union nuts and remove the No. 4 injection pipe.



5. REMOVE WIRING HARNESS CLAMP BRACKET


    A267354E01
  1. Detach the wire harness clamp.
    Text in Illustration 
    *1
    Wiring Harness Clamp Bracket

  1. Remove the bolt and wiring harness clamp bracket.



6. REMOVE NO. 2 FUEL PIPE


    A271615
  1. Using a 6 mm hexagon wrench, remove the supply pump hollow screw and gasket.
    Text in Illustration 
    V100135
    Supply Pump Hollow Screw
    V100136
    Fuel Check Valve

  1. Remove the fuel check valve, No. 2 fuel pipe and gasket.



7. REMOVE NO. 3 NOZZLE LEAKAGE PIPE


    A252280
  1. Disconnect the 3 fuel hoses.
    Text in Illustration 
    V100136
    Fuel Check Valve

  1. Remove the 2 bolts.

  1. Remove the fuel check valve, gasket and No. 3 nozzle leakage pipe.



8. REMOVE NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY


    A271661
  1. Remove the 3 bolts.
    Text in Illustration 
    V100136
    Union Bolt

  1. Remove the union bolt, gasket and No. 2 nozzle leakage pipe.



9. REMOVE OIL FILTER SUB-ASSEMBLY


    A227248E01
  1. Using SST, remove the oil filter.

    SST
    09228-07501  

    HINT:
    Insert the drain hose in the oil filter. Put the disposal container beneath the drain hose to collect the oil from the oil filter.



10. REMOVE VACUUM CONTROL VALVE SET


    A271627
  1. Disconnect the 2 vacuum switching valve connectors and 3 vacuum hoses.

  1. Remove the 2 bolts and vacuum control valve set.



11. REMOVE COMMON RAIL ASSEMBLY
  1. Disconnect the pressure discharge valve connector.



    A271664
  1. Remove the 2 bolts and common rail.

    NOTICE:
    Do not remove the pressure discharge valve.