CAN COMMUNICATION SYSTEM (w/ VSC) > ECM Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| ECM Communication Stop Mode | Either condition is met:
|
|


| 1.CHECK HARNESS AND CONNECTOR (ECM - BATTERY AND BODY GROUND) |
for 1GR-FE:

| *a | Front view of wire harness connector (to ECM) | - | - |
Disconnect the E14, E15 and E17 ECM connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E14-3 (BATT) - Body ground | Always | 11 to 14 V |
| E14-1 (+B) - Body ground | Battery positive (+) voltage applied to terminal E14-8 (MREL) | 11 to 14 V |
| E14-2 (+B2) - Body ground | Battery positive (+) voltage applied to terminal E14-8 (MREL) | 11 to 14 V |
| E14-9 (IGSW) - Body ground | Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E17-1 (E1) - Body ground | Always | Below 1 Ω |
| E15-7 (E01) - Body ground | Always | Below 1 Ω |
| E15-6 (E02) - Body ground | Always | Below 1 Ω |
for 1KD-FTV:

| *a | Front view of wire harness connector (to ECM) | - | - |
Disconnect the E4, E5, E6 and E7 ECM connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E5-2 (BATT) - Body ground | Always | 11 to 14 V |
| E4-1 (+B) - Body ground | Battery positive (+) voltage applied to terminal E4-8 (MREL) | 11 to 14 V |
| E4-9 (IGSW) - Body ground | Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E6-7 (E1) - Body ground | Always | Below 1 Ω |
| E7-7 (E01) - Body ground | Always | Below 1 Ω |
| E7-6 (E02) - Body ground | Always | Below 1 Ω |
| Result | Proceed to |
| OK (for 1GR-FE) | A |
| OK (for 1KD-FTV [w/ Glow Plug Controller]) | B |
| OK (for 1KD-FTV [w/o Glow Plug Controller]) | C |
| NG | D |
|
| ||||
|
| ||||
|
| ||||
| A | ||
| ||