CAN COMMUNICATION SYSTEM (w/ VSC) > Open in One Side of CAN Branch Line |
| Symptom | Trouble Area |
| 2 or more ECUs and/or sensors do not appear on the intelligent tester "Bus Check" screen. |
|

| 1.CHECK FOR OPEN IN ONE SIDE OF CAN BRANCH WIRE (SKID CONTROL ECU) |
Disconnect the S25 brake actuator assembly (skid control ECU) connector.
Select "Bus Check" on the intelligent tester (Click here).
| Result | Proceed to |
| "Skid Control (ABS/VSC/TRAC)" is not displayed on the intelligent tester | A |
| Several ECUs and sensors in addition to "Skid Control (ABS/VSC/TRAC)" are displayed on the intelligent tester | B |
|
| ||||
| A | |
| 2.CHECK FOR OPEN IN ONE SIDE OF CAN BRANCH WIRE (SKID CONTROL ECU CAN BRANCH WIRE) |
![]() |
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the CAN main wire and the CAN branch wire.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| S25-25 (CANH) - S25-14 (CANL) | Ignition switch off | 54 to 69 Ω |
| *a | Front view of wire harness connector (to Brake Actuator Assembly [Skid Control ECU]) |
|
| ||||
| OK | ||
| ||
| 3.CHECK FOR OPEN IN ONE SIDE OF CAN BRANCH WIRE (YAW RATE SENSOR ASSEMBLY) |
Disconnect the Y1 yaw rate sensor assembly connector.
Select "Bus Check" on the intelligent tester (Click here).
| Result | Proceed to |
| "Yaw Rate Sensor" is not displayed on the intelligent tester | A |
| Several ECUs and sensors in addition to "Yaw Rate Sensor" are displayed on the intelligent tester | B |
|
| ||||
| A | |
| 4.CHECK FOR OPEN IN ONE SIDE OF CAN BRANCH WIRE (YAW RATE SENSOR ASSEMBLY CAN BRANCH WIRE) |
![]() |
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the CAN main wire and the CAN branch wire.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| Y1-3 (CANH) - Y1-2 (CANL) | Ignition switch off | 54 to 69 Ω |
| *a | Front view of wire harness connector (to Yaw Rate Sensor Assembly) |
|
| ||||
| OK | ||
| ||
| 5.CHECK FOR OPEN IN ONE SIDE OF CAN BRANCH WIRE (STEERING ANGLE SENSOR CAN BRANCH WIRE) |
![]() |
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the CAN main wire and the CAN branch wire.
Disconnect the S31 spiral cable sub-assembly (steering angle sensor) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| S31-4 (CANH) - S31-3 (CANL) | Ignition switch off | 54 to 69 Ω |
| *a | Rear view of wire harness connector (to Spiral Cable Sub-assembly [Steering Angle Sensor]) |
|
| ||||
| OK | ||
| ||