NAVIGATION SYSTEM > Parking Brake Switch Circuit |

| 1.CHECK PARKING BRAKE SWITCH ASSEMBLY |
![]() |
Display the "Connection Status" screen (Click here).
Check that the display changes between On and Off according to the parking brake operation.
| Parking Brake Condition | Display |
| Applied | On |
| Released | Off |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - PARKING BRAKE SWITCH ASSEMBLY) |
Disconnect the N6 navigation receiver assembly connector.
Disconnect the P3 parking brake switch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| N6-6 (PKB) - P3-1 | Always | Below 1 Ω |
| N6-6 (PKB) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT PARKING BRAKE SWITCH ASSEMBLY |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| Switch connector terminal - Switch body | On (Shaft not pressed) | Below 1 Ω |
| Off (Shaft pressed) | 10 kΩ or higher |
![]() | On |
![]() | Off |
|
| ||||
| OK | ||
| ||