DTC B15C2 Speed Signal Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| B15C2 | A difference between the GPS speed and SPD pulse is detected. |
|

| 1.CHECK VEHICLE SENSOR (OPERATION CHECK) |
![]() |
Display the "Connection Status" screen (Click here).
While driving the vehicle, check that the value and gauge change in response to changes in vehicle speed.
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - COMBINATION METER ASSEMBLY) |
Disconnect the N5 navigation receiver assembly connector.
Disconnect the C26 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| N5-17 (SPD) - C26-6 | Always | Below 1 Ω |
| N5-17 (SPD) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK COMBINATION METER ASSEMBLY |
![]() |
Remove the combination meter assembly with the connector(s) still connected.
Connect an oscilloscope to terminal C26-6 and body ground.
Check the signal waveform according to the condition(s) in the table below.
| Item | Condition |
| Terminal No. (Symbol) | C26-6 - Body ground |
| Tool setting | 5 V/DIV., 20 ms./DIV. |
| Condition | Vehicle being driven at approximately 20 km/h (12mph) |
| *a | Component with harness connected (Combination Meter Assembly) |
|
| ||||
| OK | ||
| ||