Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

DTC    B158F    AV Signal Stoppage (Low Battery Voltage)


DESCRIPTION

This DTC is stored when a video or audio signal is interrupted due to battery voltage input to the navigation receiver assembly dropping temporarily.

DTC No.
DTC Detection Condition
Trouble Area
B158F
A video or audio signal is interrupted when the battery voltage drops.
Navigation receiver assembly

WIRING DIAGRAM


E278019E08


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK VEHICLE SIGNAL (OPERATION CHECK)


    E282022
  1. Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal in Operation Check (Click here).

  1. Check that the battery voltage.

    Standard voltage:
    11 to 14 V

    HINT:
    This display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.



NG
Go to step 3
OK


2.CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check that no DTCs are output (Click here).

    OK:
    No DTCs are output.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)  

3.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY POWER SOURCE)


    E178447E78
  1. Disconnect the navigation receiver assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    N8-4 (B) - Body ground
    Always
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Navigation Receiver Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)