The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the radio receiver removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
55667
3.REMOVE INSTRUMENT PANEL REGISTER BEZEL GARNISH
55011A
4.REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY
55012A
5.REMOVE NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY
55405B
6.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
86120
7.REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET
Remove the 4 screws.
Pull out the radio receiver assembly with bracket.
Disconnect all the connectors and remove the radio receiver assembly with bracket.
86211
8.REMOVE NO. 1 RADIO BRACKET
Remove the 3 screws and No. 1 radio bracket from the radio receiver assembly.
86212
9.REMOVE NO. 2 RADIO BRACKET
Remove the 3 screws and No. 2 radio bracket from the radio receiver assembly.
86120
10.REMOVE RADIO RECEIVER ASSEMBLY
86140A
11.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET
Remove the 4 screws.
Pull out the radio and display receiver assembly with bracket.
Disconnect all the connectors and remove the radio and display receiver assembly with bracket.
86211
12.REMOVE NO. 1 RADIO BRACKET
Remove the 3 screws and No. 1 radio bracket from the radio and display receiver assembly.
86212
13.REMOVE NO. 2 RADIO BRACKET
Remove the 3 screws and No. 2 radio bracket from the radio and display receiver assembly.
86140A
14.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY