The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear door speaker removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
67674A
3.REMOVE REAR DOOR FRAME GARNISH LH
4.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
74260
5.REMOVE REAR ARMREST ASSEMBLY LH
69284D
6.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH
67604
7.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
86160B
8.REMOVE REAR SPEAKER ASSEMBLY
Disconnect the connector.
Put a 5 mm (0.197 in.) drill bit into a drill.
Wind tape around the drill bit approximately 4 mm (0.157 in.) from the tip of the drill as shown in the illustration.
Tape the 4 mm (0.157 in.) drill bit to prevent the drill bit from going to deep.
| Area | Specified Condition |
|---|---|
| A | 4 mm (0.157 in.) |
Lightly press the drill against the rivets, drill off the flanges of the 3 rivets and remove the rear speaker assembly.
Be careful of the drilled rivet as it may become hot.
Pressing the drill too firmly will cause the rivet to turn and result in the rivet not being drilled through.
Do not pry the rivet with the drill because this may cause damage to the installation holes of the rivet or the drill bit.
Continue drilling and push out the remaining rivet fragments.
Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.