Home › Audio / Visual / Telematics › AUDIO / VIDEO › AMPLIFIER ANTENNA
RM33K0E _56 Audio / Visual / Telematics _043541 AUDIO / VIDEO _0213898 AMPLIFIER ANTENNA A

AUDIO / VIDEO  AMPLIFIER ANTENNA  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the amplifier antenna removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Disconnect cable from negative battery terminal w/ Power Back Door System:
Reset back door close position
Power back door system (Click here)

CAUTION:
B403904

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 63310 3.REMOVE ROOF HEADLINING ASSEMBLY

Hide 86300B 4.REMOVE NO. 1 AMPLIFIER ANTENNA ASSEMBLY

a.
E318989

Disconnect the connector.


b.
E318990

Remove the bolt and then remove the washer and holder.


c.
E318991

Remove the No. 1 amplifier antenna assembly of the vehicle outside.


Hide 86077 5.REMOVE ANTENNA COVER KIT

a.
E318992N01
0.833,0.688 1.031,0.885 0.198,0.198 10 true (1) 1.26,0.083 1.479,0.292 0.219,0.208 10 false (2)

Detach the claws and guides and remove the No. 1 amplifier antenna assembly as indicated by the arrows in the order shown in the illustration.


b.

When reusing the No. 1 amplifier antenna assembly:

i.
E318993

Remove the seal.