86120L
1.INSTALL NAVIGATION RECEIVER ASSEMBLY
86212
2.INSTALL NO. 2 RADIO BRACKET
Install the No. 2 radio bracket to the navigation receiver assembly with the 3 screws.
86211
3.INSTALL NO. 1 RADIO BRACKET
Install the No. 1 radio bracket to the navigation receiver assembly with the 3 screws.
86120L
4.INSTALL NAVIGATION ANTENNA CORD SUB-ASSEMBLY WITH BRACKET
Connect all the connectors.
Insert the navigation receiver assembly with bracket.
When inserting the navigation receiver assembly, do not press the knobs on it.
Install the navigation receiver assembly with bracket with the 4 screws.
55405B
5.INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
55011A
6.INSTALL NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY
55012A
7.INSTALL NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY
55667
8.INSTALL INSTRUMENT PANEL REGISTER BEZEL GARNISH
9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).