When the power back door cannot be closed using the back door control switch, either of the following may be malfunctioning: 1) back door control switch circuit or 2) multiplex network door ECU.
If the replacement, removal and installation of the multiplex network door ECU or disconnection of the connectors of the multiplex network door ECU has been performed, initialize the power back door system.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>INITIALIZATION
Read the Data List according to the display on the GTS.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>DATA LIST / ACTIVE TEST
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| PBD Close SW | Back door control switch signal | ON or OFF | ON: Back door control switch pushed
OFF: Back door control switch not pushed |
- |
| Tester Display |
|---|
| PBD Close SW |
On GTS screen, item changes between ON and OFF according to above chart.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the back door control switch.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR CONTROL SWITCH>REMOVAL
Inspect the back door control switch.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR CONTROL SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the V20 back door control switch connector.
Disconnect the V12 multiplex network door ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| V20-4 - V12-4 (BDDN) | Always | Below 1 Ω |
| V20-1 - Body ground | Always | Below 1 Ω |
| V20-4 or V12-4 (BDDN) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG