Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
67939B
1.REMOVE CENTER BACK DOOR GARNISH
67938A
2.REMOVE BACK DOOR SIDE GARNISH LH
67937B
3.REMOVE BACK DOOR SIDE GARNISH RH
74811D
4.REMOVE DOOR PULL HANDLE
67750
5.REMOVE BACK DOOR TRIM BOARD ASSEMBLY
67847A
6.REMOVE BACK DOOR SERVICE HOLE COVER (w/ Cover)
84280D
7.REMOVE POWER BACK DOOR SENSOR ASSEMBLY LH
68920
8.REMOVE POWER BACK DOOR UNIT ASSEMBLY LH
Disconnect the connector.
| *a | Grommet |
|
Protective Tape |
Detach the grommet.
Using a thin-bladed screwdriver with its tip wrapped in protective tape, remove the 2 stop rings along their grooves.
Detach the 2 ball joints and remove the back door stay assembly LH.
Remove the power back door unit assembly set LH while supporting the back door by hand.
68946
9.REMOVE UPPER BACK DOOR DAMPER STAY BRACKET LH
Remove the 2 bolts and upper back door damper stay bracket LH.
68948
10.REMOVE LOWER BACK DOOR DAMPER STAY BRACKET LH
Remove the 2 bolts and lower back door damper stay bracket LH.