85292A
1.REMOVE REAR WIPER ARM HEAD CAP
2.REMOVE REAR WIPER ARM AND BLADE ASSEMBLY
85143R
3.REMOVE REAR WIPER MOTOR GROMMET
67939B
4.REMOVE CENTER BACK DOOR GARNISH
Detach the clip and claw and remove the center back door garnish.
67938A
5.REMOVE BACK DOOR SIDE GARNISH LH
|
Place Hands Here |
Detach the claw and clip and remove the back door side garnish LH.
67937B
6.REMOVE BACK DOOR SIDE GARNISH RH
Use the same procedure as for the LH side.
74811D
7.REMOVE DOOR PULL HANDLE
Detach the claw and remove the door pull handle.
w/ Power Back Door:
Disconnect the connector.
84931C
8.REMOVE BACK DOOR CONTROL SWITCH (w/ Power Back Door)
55539
9.REMOVE SPARE SWITCH HOLE COVER (w/o Power Back Door)
Detach the claw and remove the spare switch hole cover.
67750
10.REMOVE BACK DOOR TRIM BOARD ASSEMBLY
Detach the clip and remove the back door trim board assembly.
67847A
11.REMOVE BACK DOOR SERVICE HOLE COVER (w/ Cover)
|
Butyl Tape |
Remove the back door service hole cover.
Remove any remaining butyl tape from the back door panel.
84280D
12.REMOVE POWER BACK DOOR SENSOR ASSEMBLY LH (w/ Power Back Door)
84270G
13.REMOVE POWER BACK DOOR SENSOR ASSEMBLY RH (w/ Power Back Door)
Use the same procedure as for the LH side.
64886B
14.REMOVE BACK DOOR GLASS CHANNEL LH
64885C
15.REMOVE BACK DOOR GLASS CHANNEL RH
Use the same procedure as for the LH side.
16.REMOVE REAR SPOILER ASSEMBLY
85345R
17.REMOVE REAR WASHER NOZZLE
67290
18.REMOVE BACK DOOR DAMPER ASSEMBLY
Remove the 3 bolts.
Detach the guide and remove the back door damper assembly.
899A0A
19.REMOVE NO. 2 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (w/ Smart Entry and Start System)
81590A
20.REMOVE REAR LIGHT ASSEMBLY LH
81580A
21.REMOVE REAR LIGHT ASSEMBLY RH
Use the same procedure as for the LH side.
76801
22.REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY
84840G
23.REMOVE BACK DOOR OPENER SWITCH ASSEMBLY
81690A
24.REMOVE LICENSE PLATE LIGHT ASSEMBLY LH
81270D
25.REMOVE LICENSE PLATE LIGHT ASSEMBLY RH
86790D
26.REMOVE REAR TELEVISION CAMERA ASSEMBLY (w/ Parking Assist Monitor System)
89222A
27.REMOVE MULTIPLEX NETWORK DOOR ECU (w/ Power Back Door)
89222A
28.REMOVE MULTIPLEX NETWORK DOOR ECU (w/ Easy Closer)
89747E
29.REMOVE POWER BACK DOOR WARNING BUZZER (w/ Power Back Door)
69350
30.REMOVE BACK DOOR LOCK ASSEMBLY (w/ Easy Closer)
69350
31.REMOVE BACK DOOR LOCK ASSEMBLY (w/o Easy Closer)
85110R
32.REMOVE REAR WIPER MOTOR ASSEMBLY
67281F
33.REMOVE LOWER BACK DOOR STOPPER
Remove the bolt.
Detach the guide and remove the lower back door stopper.
Use the same procedure as for the RH side.
67293A
34.REMOVE BACK DOOR STOPPER CUSHION
Detach the claw and remove the back door stopper cushion.
Use the same procedure as for the RH side.
67837L
35.REMOVE DOOR DUST PROOF SEAL
Detach the claw and remove the 3 door dust proof seals.
68920
36.REMOVE POWER BACK DOOR UNIT SET ASSEMBLY LH
Do not apply any horizontal load to the power back door unit set assembly in order to prevent the piston rod from deforming.
Disconnect the connector.
| *a | Grommet |
Detach the grommet.
Remove the 4 bolts and power back door unit set assembly LH.
Remove the power back door unit set assembly LH while supporting the back door by hand.
68910
37.REMOVE POWER BACK DOOR UNIT SET ASSEMBLY RH
Use the same procedure as for the LH side.