Home › Engine / Hybrid System › 1KD-FTV INTAKE / EXHAUST › INTAKE MANIFOLD
RM33K0E _51 Engine / Hybrid System _043579 1KD-FTV INTAKE / EXHAUST _0222125 INTAKE MANIFOLD A

1KD-FTV INTAKE / EXHAUST  INTAKE MANIFOLD  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the parts in the following chart (A), replace the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and/or fuel inlet pipe sub-assembly with new ones.

Replaced Parts (A) Pipes Requiring New Replacement
·

Injector assembly (including shuffling the injector assemblies between the cylinders)

·

Common rail assembly

·

Cylinder head sub-assembly


·

No. 1 injection pipe sub-assembly

·

No. 2 injection pipe sub-assembly

·

No. 3 injection pipe sub-assembly

·

No. 4 injection pipe sub-assembly


·

Supply pump assembly

·

Common rail assembly

·

Cylinder block sub-assembly

·

Cylinder head sub-assembly

·

Cylinder head gasket

·

Timing Gear Case Assembly


Fuel inlet pipe sub-assembly

·

After removing the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and fuel inlet pipe sub-assembly, clean them with a brush and compressed air.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 26100G 3.REMOVE DIESEL THROTTLE BODY ASSEMBLY

Hide 17118 4.REMOVE MANIFOLD STAY

A345132

a.

Remove the 2 bolts and manifold stay from the cylinder head sub-assembly and cylinder block sub-assembly.


Hide 11452 5.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE

A345133

a.

Remove the engine oil level dipstick.


b.

Remove the bolt and injection pipe clamp.


c.

Remove the bolt and engine oil level dipstick guide.


d.

Remove the O-ring from the engine oil level dipstick guide.


Hide 25861C 6.REMOVE VACUUM SWITCHING VALVE BRACKET

a.
A233088

Remove the 2 bolts and vacuum switching valve bracket.


Hide 17873A 7.REMOVE NO. 2 INTAKE AIR CONNECTOR BRACKET

a.
A110300

Remove the 3 bolts and No. 2 intake air connector bracket from the cylinder head sub-assembly and intake manifold.


Hide 17861F 8.REMOVE INTAKE AIR CONNECTOR

a.

Remove the 2 nuts, bolt and intake air connector from the intake manifold.


Hide 23701 9.REMOVE NO. 1, NO. 2 AND NO. 3 INJECTION PIPE SUB-ASSEMBLY

Hide 23704 10.REMOVE NO. 4 INJECTION PIPE SUB-ASSEMBLY

Hide 23770 11.REMOVE NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY

Hide 17111 12.REMOVE INTAKE MANIFOLD

A099626

a.

Disconnect the vacuum hose and vacuum switching valve connector from the intake manifold.


b.

Remove the 4 bolts, 2 nuts, intake manifold and gasket.