The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear door lock removal/installation are shown below.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
Fully open the rear door glass sub-assembly LH before proceeding with work.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
67674A
3.REMOVE REAR DOOR FRAME GARNISH LH
74260
4.REMOVE REAR ARMREST ASSEMBLY LH
5.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
69284D
6.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH
67604
7.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
67842E
8.REMOVE REAR DOOR SERVICE HOLE COVER LH
68152C
9.REMOVE REAR DOOR GLASS RUN LH
67408E
10.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH
68104
11.REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH
67836H
12.REMOVE REAR DOOR LOCK CHILD PROTECTION COVER LH
69340
13.REMOVE REAR DOOR LOCK ASSEMBLY LH
| *a | Release Plate |
|
"Torx" Screw |
|
Connector |
|
Remove in this Direction |
Disconnect the connector.
Using a T30 "TORX" socket wrench, remove the 3 screws.
Slide the rear door lock assembly RH downward, and pull the release plate out of the rear door outside handle frame sub-assembly LH.
69038A
14.REMOVE REAR DOOR LOCK COVER SUB-ASSEMBLY LH
|
Protective Tape |
Using a thin-bladed screwdriver, detach the claw and clamp and remove the rear door lock cover sub-assembly LH from the rear door lock assembly LH.
Tape the thin-bladed screwdriver tip before use.
69740D
15.REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH
|
Remove in this Direction |
Detach the guide and remove the rear door lock remote control cable assembly LH from the rear door lock assembly LH.
69780B
16.REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH
|
Remove in this Direction |
Detach the guide and remove the rear door inside locking cable assembly LH from the rear door lock assembly LH.
69318D
17.REMOVE DOOR LOCK WIRING HARNESS SEAL
Remove the door lock wiring harness seal from the rear door lock assembly LH.