69350
1.INSTALL BACK DOOR LOCK ASSEMBLY (w/ Power Back Door)
When installing a new back door lock assembly, if there is any tape stuck to it, remove the tape.
When installing a new back door lock assembly, if there are any strings attached to it, cut the strings off.
Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.
Apply MP grease to the sliding parts of the back door lock assembly.
|
Bolt |
|
Connector |
|
Install in this Direction |
Install the back door lock assembly with the 4 bolts.
Connect the 2 connectors.
69350
2.INSTALL BACK DOOR LOCK ASSEMBLY (w/o Power Back Door)
When installing a new back door lock assembly, if there is any tape stuck to it, remove the tape.
When installing a new back door lock assembly, if there are any strings attached to it, cut the strings off.
Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.
Apply MP grease to the sliding parts of the back door lock assembly.
|
Bolt |
|
Connector |
|
Install in this Direction |
Install the back door lock assembly with the 3 bolts.
Connect the connector.
89222A
3.INSTALL MULTIPLEX NETWORK DOOR ECU (w/ Power Back Door)
89222A
4.INSTALL MULTIPLEX NETWORK DOOR ECU (w/ Easy Closer)
67847A
5.INSTALL BACK DOOR SERVICE HOLE COVER (w/ Cover)
67750
6.INSTALL BACK DOOR TRIM BOARD ASSEMBLY
74811D
7.INSTALL DOOR PULL HANDLE
67938A
8.INSTALL BACK DOOR SIDE GARNISH LH
67937B
9.INSTALL BACK DOOR SIDE GARNISH RH
67939B
10.INSTALL CENTER BACK DOOR GARNISH
11.INSPECT POWER BACK DOOR SYSTEM (w/ Power Back Door)
12.INSPECT BACK DOOR CLOSER SYSTEM (w/ Easy Closer)