Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL RECEIVER
RM33K0E _58 Vehicle Interior _043547 DOOR LOCK _0222455 DOOR CONTROL RECEIVER A

DOOR LOCK  DOOR CONTROL RECEIVER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the door control receiver removal/installation are shown below.

Necessary Procedures After Parts Removed / Installed / Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal
w/ Power Back Door System:

Reset back door close position


Power back door system (Click here)

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedures listed below are for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:
B394719

Be sure to read Precaution thoroughly before servicing.

for Type A:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type A)>PRECAUTION

for Type B:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION


NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
B394718

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 55302A 3.REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 89740A 4.REMOVE SMART DOOR CONTROL RECEIVER ASSEMBLY (w/ Smart Entry and Start System)

a.
B438675C01
0,0 0,0 false
V100135

Nut
V100136

Connector


Remove the nut.


b.

Detach the guide and remove the smart door control receiver assembly.


c.

Disconnect the connector.


Hide 89741 5.REMOVE DOOR CONTROL RECEIVER (w/o Smart Entry and Start System)

a.
B438676C01
0,0 0,0 false
V100135

Nut
V100136

Connector


Remove the nut.


b.

Detach the guide and remove the door control receiver.


c.

Disconnect the connector.