The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication.
Refer to Brake Warning Light Remains ON.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>Brake Warning Light Remains ON
When replacing the skid control ECU (brake actuator assembly), perform Test Mode (Signal Check) to acquire the rear differential lock identification information.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>TEST MODE PROCEDURE
Check if CAN communication system DTCs are output.
for LHD: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD)>DIAGNOSIS SYSTEM
for RHD: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD)>DIAGNOSIS SYSTEM
| Proceed to |
|---|
| DTC is not output |
| DTC is output |
DTC is not output
DTC is output
for LHD: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD)>HOW TO PROCEED WITH TROUBLESHOOTING
for RHD: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD)>HOW TO PROCEED WITH TROUBLESHOOTING
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.
According to the display on the GTS, perform the Active Test.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Brake Warning Light | Brake warning light | Warning light OFF/ON | Observe combination meter
Vehicle condition: Vehicle stopped |
When performing the Brake Warning Light Active Test, check Brake Warning Light in the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Brake Warning Light | Brake warning light | OFF or ON | OFF: Warning light off
ON: Warning light on |
- |
| Active Test Display |
|---|
| Brake Warning Light |
| Data List Display |
|---|
| Brake Warning Light |
| Result | Proceed to |
|---|---|
| Brake warning light in the Data List does not change using the Active Test | A |
| Brake warning light in the Data List turns ON/OFF using the Active Test | B |
A
B
Turn the ignition switch off.
Perform Active Test of the combination meter assembly using the GTS.
| Tester Display |
|---|
| Indicat. Lamp Brake |
Check the combination meter assembly.
The brake warning light turns on or off in accordance with the GTS.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING