Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
84340
1.INSTALL STOP LIGHT SWITCH ASSEMBLY
55106
2.INSTALL BRAKE PEDAL SUPPORT SUB-ASSEMBLY
Install the nut to the brake pedal support sub-assembly.
Install the brake pedal support sub-assembly with the 4 nuts.
Install the brake pedal support reinforcement set bolt.
Attach the 2 clamps to the brake pedal support sub-assembly.
Connect the connector to the stor light switch assembly.
47264A
3.INSTALL PUSH ROD PIN
|
Lithium soap base glycol grease |
Apply a light coat of lithium soap base glycol grease to the push rod pin and installation hole of the brake pedal support sub-assembly.
Set the push rod clevis in place, insert the push rod pin from inside the vehicle, and then attach a new clip.
After installation, check that the pedal operates smoothly.
47101A
4.INSTALL BRAKE PEDAL RETURN SPRING
Install the brake pedal return spring to the brake pedal support sub-assembly and push rod pin.
5.CHECK AND ADJUST BRAKE PEDAL HEIGHT
55302A
6.INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY
7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION