Home › Brake › BRAKE (FRONT) › FRONT BRAKE
RM33K0E _54 Brake _043535 BRAKE (FRONT) _0223433 FRONT BRAKE A

BRAKE (FRONT)  FRONT BRAKE  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 43512 1.INSTALL FRONT DISC

a.
C321911C01
1.719,1.208 1.708,0.854 1.708,0.854 2.833,0.854 true 1.729,1.292 2.375,1.292 2.375,1.292 2.375,0.865 true 2.927,0.781 3.125,0.948 0.198,0.167 10 false *a
*a Matchmark


Align the matchmarks and install the front disc.

HINT:

When replacing the disc with a new one, select the installation position where the front disc has the smallest runout.



Hide 47750 2.INSTALL DISC BRAKE CYLINDER ASSEMBLY LH

a.

Install the disc brake cylinder assembly LH with the 2 bolts.

Torque:
197 N*m (2009 kgf*cm, 145 ft.*lbf)


Hide 47343A 3.CONNECT FRONT NO. 1 WHEEL CYLINDER TUBE LH

a.
A329093C03
1.719,0.542 2.031,0.698 0.313,0.156 10 false *a
*a Torque Wrench Fulcrum Length


Using a union nut wrench, connect the front No. 1 wheel cylinder tube LH to the disc brake cylinder assembly LH.

Torque:
Specified tightening torque : 15.2 N*m (155 kgf*cm, 11 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum length of 162 mm (6.3779 in.)): 13.4 N*m (137 kgf*cm, 10 ft.*lbf)




Hide 04945 4.INSTALL FRONT ANTI-SQUEAL SHIM KIT

a.

Install the front No. 1 anti-squeal shims to the each pad.

NOTICE:

When replacing worn front disc brake pads, the anti-squeal shims must be replaced together with the front disc brake pads.



Hide 04465 5.INSTALL FRONT DISC BRAKE PAD

a.

Install the 2 front disc brake pads to the disc brake cylinder assembly LH.

NOTICE:

Make sure there is no oil or grease on the friction surface of the front disc brake pads and front disc.



Hide 04947 6.INSTALL FRONT DISC BRAKE ANTI-RATTLE SPRING

a.

Install the 2 disc brake pad guide pins and front disc brake anti-rattle spring.


b.

Install the 2 pin hold clips.

NOTICE:

When installing the pin hold clip, be sure to install the pin hold clip with the handle facing the center of the vehicle.



Hide 7.BLEED BRAKE LINE (w/ VSC)

Hide 8.BLEED BRAKE LINE (w/o VSC)

Hide 9.BLEED CLUTCH LINE (for Manual Transmission)

Hide 10.INSTALL FRONT WHEEL