Home › Engine / Hybrid System › 1KD-FTV LUBRICATION › ENGINE OIL COOLER
RM33K0E _51 Engine / Hybrid System _043585 1KD-FTV LUBRICATION _0225055 ENGINE OIL COOLER A

1KD-FTV LUBRICATION  ENGINE OIL COOLER  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the parts in the following chart (A), replace the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and/or fuel inlet pipe sub-assembly with new ones.

Replaced Parts (A) Pipes Requiring New Replacement
·

Injector assembly (including shuffling the injector assemblies between the cylinders)

·

Common rail assembly

·

Cylinder head sub-assembly


·

No. 1 injection pipe sub-assembly

·

No. 2 injection pipe sub-assembly

·

No. 3 injection pipe sub-assembly

·

No. 4 injection pipe sub-assembly


·

Supply pump assembly

·

Common rail assembly

·

Cylinder block sub-assembly

·

Cylinder head sub-assembly

·

Cylinder head gasket

·

Timing Gear Case Assembly


Fuel inlet pipe sub-assembly

·

After removing the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and fuel inlet pipe sub-assembly, clean them with a brush and compressed air.



PROCEDURE

Hide 15710 1.INSTALL OIL COOLER ASSEMBLY

a.

Install 2 new gaskets to the oil cooler assembly.


b.

Install the oil cooler assembly to the oil cooler cover sub-assembly with the 4 nuts.

Torque:
16 N*m (163 kgf*cm, 12 ft.*lbf)


Hide 15701C 2.INSTALL OIL COOLER COVER SUB-ASSEMBLY

a.

Install a new gasket and the oil cooler cover sub-assembly with the 13 bolts.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


b.

Connect the No. 2 vacuum transmitting pipe sub-assembly with the 2 nuts.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


c.

Connect the connector to the engine oil pressure switch assembly.


Hide 15601 3.INSTALL OIL FILTER SUB-ASSEMBLY

Hide 23810A 5.INSTALL COMMON RAIL ASSEMBLY

Hide 22100 6.INSTALL FUEL SUPPLY PUMP ASSEMBLY

Hide 51410 13.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY