Home › Engine / Hybrid System › 2TR-FE INTAKE / EXHAUST › EXHAUST MANIFOLD
RM33K0E _51 Engine / Hybrid System _043522 2TR-FE INTAKE / EXHAUST _0225353 EXHAUST MANIFOLD A

2TR-FE INTAKE / EXHAUST  EXHAUST MANIFOLD  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the exhaust manifold removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Gas leaks from exhaust system Inspection After Repair Poor idle, engine start, etc. (Click here)

CAUTION:
·
A343693

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.

·
A350542

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.



PROCEDURE

Hide 53882F 1.REMOVE FRONT FENDER SEAL RH

Hide 25710 2.REMOVE AIR SWITCHING VALVE ASSEMBLY (w/ Secondary Air Injection System)

Hide 17705 3.REMOVE AIR CLEANER CAP SUB-ASSEMBLY WITH NO. 1 AIR CLEANER HOSE (w/o Secondary Air Injection System)

Hide 17801 4.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY (w/o Secondary Air Injection System)

Hide 17701 5.REMOVE AIR CLEANER CASE SUB-ASSEMBLY (w/o Secondary Air Injection System)

Hide 17410 6.REMOVE FRONT EXHAUST PIPE ASSEMBLY

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.

Disconnect the air fuel ratio sensor connector and detach the 3 wire harness clamps.


b.

for 2WD:

Disconnect the heated oxygen sensor connector and detach the 4 wire harness clamps.


c.

for 4WD:

Disconnect the heated oxygen sensor connector and detach the wire harness clamp.


d.

Remove the 4 bolts, 2 nuts and 2 compression springs.


e.

Remove the front exhaust pipe assembly from the No. 1 exhaust pipe support.


f.

Remove the 2 gaskets.


Hide 17167 7.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR (w/o Secondary Air Injection System)

CAUTION:

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


a.
A349255

Remove the 5 bolts and No. 1 exhaust manifold heat insulator.


Hide 17118 8.REMOVE MANIFOLD STAY

CAUTION:

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


a.
A345967

Remove the 3 bolts and manifold stay.


Hide 17141 9.REMOVE EXHAUST MANIFOLD

CAUTION:

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


a.
A346103

w/o Secondary Air Injection System:

Remove the 6 nuts and exhaust manifold.


b.
A346102

w/ Secondary Air Injection System:

Remove the 8 nuts and exhaust manifold.


c.

Remove the gasket.