Home › Engine / Hybrid System › 1GD-FTV ENGINE CONTROL › CRANKSHAFT POSITION SENSOR
RM33K0E _51 Engine / Hybrid System _043518 1GD-FTV ENGINE CONTROL _0225992 CRANKSHAFT POSITION SENSOR A

1GD-FTV ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11401Q 1.INSTALL CRANKSHAFT POSITION SENSOR

a.

Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.


b.

Install the crankshaft position sensor with the bolt to the rear oil seal retainer.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

When reusing the crankshaft position sensor, check the O-ring.

·

Make sure that the O-ring is not cracked or jammed when installing to the rear oil seal retainer.

·

Replace with a new part if it is dropped or if it receives a strong impact.




Hide 2.INSTALL CRANKSHAFT POSITION SENSOR HARNESS BRACKET

a.

Install the crankshaft position sensor harness bracket with the bolt to the cylinder block sub-assembly.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 27148C 3.INSTALL CONNECTING WIRE

a.

Connect the 2 connectors and clamp and install the connecting wire.


Hide 12585 4.INSTALL NO. 5 CYLINDER BLOCK INSULATOR

Hide 12581A 5.INSTALL NO. 1 CYLINDER BLOCK INSULATOR

Hide 31250 8.INSTALL CLUTCH DISC ASSEMBLY (for Manual Transmission)

Hide 31210 9.INSTALL CLUTCH COVER ASSEMBLY (for Manual Transmission)

Hide 10.INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)

Hide 11.INSTALL MANUAL TRANSMISSION ASSEMBLY (for Manual Transmission)