Home › Engine / Hybrid System › 1GD-FTV ENGINE CONTROL › POWER STEERING OIL PRESSURE SWITCH
RM33K0E _51 Engine / Hybrid System _043518 1GD-FTV ENGINE CONTROL _0225997 POWER STEERING OIL PRESSURE SWITCH A

1GD-FTV ENGINE CONTROL  POWER STEERING OIL PRESSURE SWITCH  INSTALLATION  


PROCEDURE

Hide 89438D 1.INSTALL POWER STEERING OIL PRESSURE SWITCH

a.

Apply a light coat of engine oil to the O-ring of the power steering oil pressure switch.


b.

Using a 19 mm deep socket wrench, install the power steering oil pressure switch.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)

NOTICE:
·

Do not allow foreign matter to contact the oil seal face of the power steering oil pressure switch (the surface that contacts the pressure feed tube).

·

Be careful not to damage the O-ring when installing the power steering oil pressure switch.




c.

Connect the power steering oil pressure switch connector.


Hide 2.ADD POWER STEERING FLUID

Hide 3.BLEED AIR FROM POWER STEERING SYSTEM

Hide 4.CHECK FOR POWER STEERING FLUID LEAK

Hide 12601B 5.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY