The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the steering knuckle removal/installation are shown below.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE FRONT WHEEL
89543
2.DISCONNECT FRONT SPEED SENSOR LH
Detach the clamp.
Remove the bolt and harness clamp.
Detach the clamp.
Remove the bolt and front speed sensor LH from the steering knuckle LH.
Keep the sensor tip and sensor installation hole free from foreign matter.
Remove the bolt and skid control sensor clamp from the steering knuckle LH.
47750
3.REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY LH
43512
4.REMOVE FRONT DISC
Click hereBrake>BRAKE (FRONT)>FRONT BRAKE>REMOVAL
43514C
5.REMOVE FRONT AXLE HUB GREASE CAP (for 4WD)
43502H
6.REMOVE FRONT AXLE SHAFT NUT LH (for 4WD)
48810
7.DISCONNECT FRONT STABILIZER LINK ASSEMBLY LH
Remove the nut and disconnect the front stabilizer link assembly LH from the steering knuckle LH.
If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.
8.DISCONNECT TIE ROD END SUB-ASSEMBLY LH
48069
9.DISCONNECT FRONT LOWER NO. 1 SUSPENSION ARM ASSEMBLY LH
Remove the 2 bolts, and disconnect the front lower No. 1 suspension arm assembly LH from the steering knuckle.
48630
10.DISCONNECT FRONT UPPER SUSPENSION ARM ASSEMBLY LH
| *a | Turn |
| *b | Hold |
Remove the clip and nut.
Using SST, disconnect the front upper suspension arm assembly LH from the steering knuckle LH.
43502K
11.REMOVE FRONT AXLE HUB DUST SEAL (for 4WD)
Using a screwdriver and hammer, tap out the front axle hub dust seal.
43442B
12.REMOVE KNUCKLE GREASE RETAINER CAP LH (for Pre-Runner)
Using a screwdriver and hammer, remove the knuckle grease retainer cap LH.
43212
13.REMOVE STEERING KNUCKLE LH
Remove the 4 bolts, dust cover and front axle hub sub-assembly LH from the steering knuckle LH.
Remove the O-ring from the front axle hub sub-assembly LH.