Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
42312C
1.INSTALL REAR AXLE SHAFT OIL SEAL LH
| *a | Depth |
Using SST and a hammer, tap in a new rear axle shaft oil seal LH.
6.3 to 7.3 mm (0.249 to 0.287 in.)
Coat the lip of the rear axle shaft oil seal LH with MP grease.
42422B
2.INSTALL REAR AXLE BEARING CASE O-RING LH
Install a new rear axle bearing case O-ring LH to the rear axle housing.
3.INSTALL REAR AXLE SHAFT WITH BACKING PLATE
Install the rear axle shaft with backing plate with the 4 nuts.
89546
4.CONNECT REAR SPEED SENSOR LH
Connect the rear speed sensor LH to the rear axle housing with the bolt.
46430
5.CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
Connect the No. 3 parking brake cable assembly with the 2 bolts.
6.INSTALL PARKING BRAKE ASSEMBLY
7.ADJUST PARKING BRAKE
8.INSTALL REAR WHEEL
9.CHECK ABS SPEED SENSOR SIGNAL