Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
48231B
1.INSTALL REAR COIL SPRING LH
| *a | 10 to 20 mm (0.394 to 0.787 in.) |
Temporarily install the rear coil spring LH to the lower control arm assembly LH as shown in the illustration.
10 to 20 mm (0.394 to 0.787 in.)
Temporarily install the rear coil spring LH and rear upper coil spring insulator LH with the bolt and nut.
46430
2.CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
Connect the No. 3 parking brake cable assembly with the bolt.
48341B
3.INSTALL REAR NO. 1 SPRING BUMPER LH
Install the rear No. 1 spring bumper LH to the frame with the 2 bolts.
4.INSTALL REAR WHEEL
5.STABILIZE SUSPENSION
48730
6.TIGHTEN LOWER CONTROL ARM ASSEMBLY LH
Tighten the 2 bolts.
While fixing the nut in place, tighten the bolts.
7.PERFORM INITIALIZATION (w/ Automatic Headlight Beam Level Control System)
8.INSPECT AUTOMATIC LIGHT CONTROL SYSTEM (w/ Automatic Headlight Beam Level Control System)
9.INSPECT HEADLIGHT AIMING (w/ Automatic Headlight Beam Level Control System)