Home › Suspension › REAR SUSPENSION › REAR UPPER ARM
RM33K0E _53 Suspension _043531 REAR SUSPENSION _0226854 REAR UPPER ARM A

REAR SUSPENSION  REAR UPPER ARM  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 48710 1.TEMPORARILY INSTALL UPPER CONTROL ARM ASSEMBLY

a.

Temporarily install the upper control arm assembly with the 2 bolts and 2 nuts.


Hide 89408C 2.CONNECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Automatic Headlight Beam Level Control System)

a.

Connect the rear height control sensor sub-assembly LH with the nut.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 48710 5.TIGHTEN UPPER CONTROL ARM ASSEMBLY

a.

Tighten the 2 bolts.

Torque:
145 N*m (1479 kgf*cm, 107 ft.*lbf)

HINT:

While fixing the nut in place, tighten the bolts.



Hide 6.PERFORM INITIALIZATION (w/ Automatic Headlight Beam Level Control System)

Hide 7.INSPECT AUTOMATIC LIGHT CONTROL SYSTEM (w/ Automatic Headlight Beam Level Control System)

Hide 8.INSPECT HEADLIGHT AIMING (w/ Automatic Headlight Beam Level Control System)